South East Asia Iron and Steel Institute
PT Krakatau Posco Competitive Steel Plate Structure for Wind Power Segmentation
by Prananajaya Alan
Amid the scarcity of oil and natural gas, wind energy is becoming the alternative. Besides its environmental friendly, wind energy can be applied on both onshore and offshore area as
well. Many deve ...
Read More
PTI Lime Injection System Operating Results and Experience at 120 t EAF
by Jaroslav Brhel, Christopher Farmer
Process Technology International (PTI) has recently developed and commissioned an innovative system for lime introduction to the EAF. This paper describes the practical operating results achieved when ...
Read More
Pulverized Coal Injection - Paul Wurth’s Technology for New Installations and Plant Upgrades
by P. Mahowald, E. Censi, D. Michels
Pulverized Coal Injection
-
Paul Wurth’s Technology for New Installations and Plant Upgrades
Read More
Quality Advantage & Progress in DSC Hot-Rolled-Coil
by Chieh-Hsiang Tseng
Since 2010.04 the 1st Hot-Roll-Coil output, Dragon Steel Corporation (DSC) produced HRC more than 20 million tons till now. In order to achieve good surface quality, precise thickness and width, and u ...
Read More
Quality Improvement of Round Bars for Structural Use
by Yoshihiro Otagaki, Daigo Kaneko, Katsuyuki Isogami
Godo Steel Himeji Works produce round bars for structural use. Recently special steel users have been demanding higher and higher needs, which include such as to prevent distribution of bended product ...
Read More
Quality Improvements of Bloom with Two Continuous Casters
by Shuhei Kitamura
The new bloom caster (NO.5CC) of Kobe Works went into operation on September 1, 2006, aiming an increase of casting capacity and a quality improvement of bar and wire rod products. NO.5CC is a two-str ...
Read More
Quality Strip Production (QSP) via Thin Slab Casting and Rolling The Ultimate Layout and Equipment Design Concepts for Superior Coil Production
by Carlo P. Piemonte, Alessandro Pigani
The direct rolling process for hot strip production, whereby the mill is directly connected to the thin slab caster, has rapidly gained ground because of its remarkable advantages over the conventiona ...
Read More
Radar Solutions for Harsh Environmental Conditions
by Dr. Bettina Fischer, Aandreas Goeke
IMS Messsysteme GmbH in cooperation with the Fraunhofer FHR has developed the first width
measurement system based on radar technology for hot rolling mills. In contrast to laser radiation or
ligh ...
Read More
RadComm Systems - Prevention of Radioactive Scrap in the Steel Industry
by RadComm, Canada
RadComm Systems - Prevention of Radioactive Scrap in the Steel Industry
Read More
