South East Asia Iron and Steel Institute
Prospect of Titania-Magnetite Bearing Iron Sand Processing to Increase the Cost Competitiveness of Seaisi Countries
by Yakov Gordon, Michiel Freislich, Leigh Harris, Len Woods
Titania-magnetite and vanadium bearing iron sand represents a largely untapped resource for SEAISI steelmakers, particularly in the regions of Indonesia and the Philippines. Recent developments in tit ...
Read More
Please login to borrow the book.
PT Krakatau Posco Competitive Steel Plate Structure for Wind Power Segmentation
by Prananajaya Alan
Amid the scarcity of oil and natural gas, wind energy is becoming the alternative. Besides its environmental friendly, wind energy can be applied on both onshore and offshore area as
well. Many deve ...
Read More
Please login to borrow the book.
PTI Lime Injection System Operating Results and Experience at 120 t EAF
by Jaroslav Brhel, Christopher Farmer
Process Technology International (PTI) has recently developed and commissioned an innovative system for lime introduction to the EAF. This paper describes the practical operating results achieved when ...
Read More
Please login to borrow the book.
Pulverized Coal Injection - Paul Wurth’s Technology for New Installations and Plant Upgrades
by P. Mahowald, E. Censi, D. Michels
Pulverized Coal Injection
-
Paul Wurth’s Technology for New Installations and Plant Upgrades
Read More
Please login to borrow the book.
Quality Advantage & Progress in DSC Hot-Rolled-Coil
by Chieh-Hsiang Tseng
Since 2010.04 the 1st Hot-Roll-Coil output, Dragon Steel Corporation (DSC) produced HRC more than 20 million tons till now. In order to achieve good surface quality, precise thickness and width, and u ...
Read More
Please login to borrow the book.
Quality Improvement of Round Bars for Structural Use
by Yoshihiro Otagaki, Daigo Kaneko, Katsuyuki Isogami
Godo Steel Himeji Works produce round bars for structural use. Recently special steel users have been demanding higher and higher needs, which include such as to prevent distribution of bended product ...
Read More
Please login to borrow the book.
Quality Improvements of Bloom with Two Continuous Casters
by Shuhei Kitamura
The new bloom caster (NO.5CC) of Kobe Works went into operation on September 1, 2006, aiming an increase of casting capacity and a quality improvement of bar and wire rod products. NO.5CC is a two-str ...
Read More
Please login to borrow the book.
Quality Strip Production (QSP) via Thin Slab Casting and Rolling The Ultimate Layout and Equipment Design Concepts for Superior Coil Production
by Carlo P. Piemonte, Alessandro Pigani
The direct rolling process for hot strip production, whereby the mill is directly connected to the thin slab caster, has rapidly gained ground because of its remarkable advantages over the conventiona ...
Read More
Please login to borrow the book.