South East Asia Iron and Steel Institute
Amid the scarcity of oil and natural gas, wind energy is becoming the alternative. Besides its environmental friendly, wind energy can be applied on both onshore and offshore area as well. Many deve ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.
Process Technology International (PTI) has recently developed and commissioned an innovative system for lime introduction to the EAF. This paper describes the practical operating results achieved when ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.
Since 2010.04 the 1st Hot-Roll-Coil output, Dragon Steel Corporation (DSC) produced HRC more than 20 million tons till now. In order to achieve good surface quality, precise thickness and width, and u ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.
Godo Steel Himeji Works produce round bars for structural use. Recently special steel users have been demanding higher and higher needs, which include such as to prevent distribution of bended product ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.
The new bloom caster (NO.5CC) of Kobe Works went into operation on September 1, 2006, aiming an increase of casting capacity and a quality improvement of bar and wire rod products. NO.5CC is a two-str ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.
The direct rolling process for hot strip production, whereby the mill is directly connected to the thin slab caster, has rapidly gained ground because of its remarkable advantages over the conventiona ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.
IMS Messsysteme GmbH in cooperation with the Fraunhofer FHR has developed the first width measurement system based on radar technology for hot rolling mills. In contrast to laser radiation or ligh ...
Buku sedia untuk dipinjam.
Sila login untuk meminjam buku.